• What should I do when using an elevated platform?
• What should I do when working near electrical conductors?
• What should I not do when using an elevated platform?

What should I do when using an elevated platform?

• Have proper training before operating controls.
• Read, understand and follow the instructions in the manufacturer's operating manual.
• Tow only vehicles that are designed specifically for that use.
• Wear a safety harness that is fixed to a platform attachment point.
• Maintain three-point contact (one hand and two feet, or two hands and one foot) when getting on or off the platform.
• Maintain firm footing on platform.
• Look in direction of travel and make sure that path is firm and level.

What should I do when working near electrical conductors?

Measure the distance to electrical wires and maintain minimum clearance distances according to safety regulations.

Measure distance from the extreme outside dimension of the work platform and equipment, the safety lines, cables, materials or tools handled to the nearest energized conductor. This conductor could be a wire, transformer or any other energized component. When the minimum distance cannot be maintained, stop all work and contact the authority controlling the electrical system for advice.

What should I not do when using an elevated platform?

• Do not exceed the rated load capacity.
• Do not use a platform without guardrails in place
• Do not enter or leave a platform when it is elevated.
• Do not use ladders or other devices on the platform to gain extra height.
• Do not stand on guardrails to gain extra height.
• Do not lean over platform railings.
• Do not climb up or down extension or scissor areas.
• Do not use a defective platform.
• Do not use the platform as a jack.
• Do not use guardrails to carry materials unless designed for this purpose.
• Do not lift loads that overhang from the platform.
• Do not use platform for pulling, pushing or dragging materials.

Want more information?

Document last updated on December 17, 2002

Copyright ©1997-2012 Canadian Centre for Occupational Health & Safety